quality-control-is-the-difference

Quality Control

Each load of pellets is carefully examined for foreign materials and tested for optimum moisture conditions. Our pellets are made from natural wood sawdust that is reduced to uniform size and dehydrated to the desired moisture level. Moisture tests are run four times each hour for pellet mill and dryer control.

Following moisture control, the pellets are pressed and shaped. The end product is then weighed and sampled for consistency. Operational equipment designed to regulate these processes is inspected hourly for optimal performance.

pfi-ceritifed-fuel quality-control-inset
Each load of pellets is carefully examined for foreign materials and tested for optimum moisture conditions.
quality-control-inset2
Each load of pellets is carefully examined for foreign materials and tested for optimum moisture conditions.
QAP Operational Step Monitoring Test Frequency
1 Receiving Collect sample for moisture analysis and record results. Visually look at product for foreign material. each load
2 Feedbeds (Chips and Sawdust) Visual observation to determine optimal speed for pelletizing process. Hourly
3 Magnet Make sure magnet is operating correctly and in place. Hourly
4 Shaker table Visually observe that shaker is operating correctly. Hourly
5 Dryer Perform Moisture tests based on operating procedure. every 15 minutes
6 Pellet Mills Perform Moisture tests based on operating procedure. every 15 minutes
7 Screen before Storage Visually observe that screen is operating correctly. every 2 hours
8 Bagger (Screen) Visually observe that screen is operating correctly. every 2 hours
9 Quality Check sample of product for quality. Hourly
10 Scaled Check 3 bag weights by placing them on a calibrated scale. Also check bag quality for holes, tears, and print quality. Hourly